Command Start CS-580i FM Podręcznik Użytkownika Pobierz pdf (Strona 3)

User Guide P. 3

With many advanced functions, this product will satisfy any one your expectations from high-end

commodity and security systems, without neglecting any standard feature commonly offered by

entry-level starters.

Remote-Starting Your Vehicle

Remote-starting

Press the START/STOP button for approx. 1 second. The parking lights will come ON and the remote

control will play a melody to inform you that the System has received your signal. Approximately 5

seconds later, the engine will start. The parking lights will remain ON during the pre-programmed

run time of the engine.

If the vehicle does not start at the first attempt, the system will shut down, wait a few seconds and

try to start the engine again. There will be 3 start attempts before the system gives up.

Vehicle Presets

Heater & Heated Seat

When leaving the vehicle it is recommended to preset the accessory controls in preparation for the

next remote start. Settings for the blower motor (fan), front and rear, as well as heated seats (if

equipped) should not be left on

HIGH. It is recommended to leave the settings on LOW or MEDIUM

instead.

Windshield Wipers & Radio & Headlights

Certain vehicles require the radio and / or windshield wiper and / or headlight circuits to become

energized while running under remote start. When leaving the vehicle you must ensure that the

windshield wiper and headlight switches are

OFF. Leaving the headlight switch ON on certain types

of vehicles could cause them to remain

ON even after remote starter shut down, resulting in a dead

battery.

Driving Off

With the vehicle running under remote control, press the

UNLOCK button to disarm and unlock the

doors. Enter the vehicle and do the following:

Turn the ignition key to the IGNITION ON (RUN) position. (Do not turn the key to the CRANK position

while the engine is running. This would cause the starter motor to re-engage.)

Press the brake pedal to disengage the remote starter unit.

You are now ready to drive off.

Using the System

Arming and Disarming the System

To disarm the alarm and Starter Kill (if installed) and unlock the doors (if installed):

1. Press and hold the UNLOCK button for approx. 1 sec.

You will hear two chirps if the Siren or Horn is so configured.

The icon will light up on the LCD display of the remote control. The parking lights will flash twice

and the L.E.D. will go out to confirm that the doors have been unlocked and that the Starter

Kill (if installed) and the alarm are disarmed.

In Passive Mode, the System will rearm automatically 30 seconds after unlocking unless the key is

meanwhile inserted in the ignition switch (see description of Passive Mode later in this Guide).

To arm the alarm and Starter Kill (if installed) and lock the doors (if installed):

1. Press and hold the LOCK button for approx. 1 sec.

You will hear one chirp if the Siren or Horn is so configured.

2. The

icon will light up on the LCD display of the remote control. The parking lights will flash

once and the L.E.D. will flash slowly to confirm that the doors have been locked and that the

Starter Kill feature (if installed) and the alarm are armed.

1 2 3 4 5 6 7 8 ... 14 15

Komentarze do niniejszej Instrukcji

Brak uwag

Command Start CS-580i FM Podręcznik Użytkownika Strona 3

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Zdalne rozruszniki Command Start CS-580i FM